My sweet little Daisy Purse was die-cut with the Petite Purse Die. To get a contrasting pattern for the flap, I laid a small piece of Floral District Designer Series Paper over just the flap section on the die. I cut off the tab on the designer paper flap only (to make it easier to slip the card stock tab into the slit to close). Then I added another designer paper strip at the bottom.
For the decorative closure, I used the small flower from the Boho Blossoms Punch and layered a small Paper Daisy onto it with a glue dot. The Rhinestone jewel was colored with a permanent marker and then added to the center of the flowers. I attached the finished flower embellishment with a glue dot just above the tab after closing the purse.
Normally, I use Sticky Strip on most of my boxes. However, Sticky Strip is a little wider than the flaps on this, so I tried the Multipurpose Liquid Glue instead...it worked beautifully! I used the Liquid Glue to assemble the box, attach the designer paper to the flap and lower edge, as well as the purse strap. I like how easy it is to control the amount of glue you're applying and it dried really quickly too!
- Whisper White Card Stock #100730
- Lucky Limeade Card Stock #122926
- Floral District Designer Series Paper #126919
- Petite Purse Die #125606
- Big Shot Die-Cutting Machine #113439
- Paper Daisies #119243
- Boho Blossoms Punch #119858
- Basic Rhinestones #119246
- Bone Folder #102300
- Glue Dots #103683
- Multipurpose Liquid Glue #110755
- Paper Snips #103579
- Permanent Marker (non-Stampin' Up!)
Comments